Circuit Schematic Wiper Speed Controller using NE555 and CD4017 ICs

Autometronicschool. - This is one of the electronic circuit schematic that will give you easy to control your car wiper speed now. This circuit named with Circuit Schematic Wiper Speed Controller using NE555 and CD4017 ICs. So, the main components that used in this circuit are NE555 and CD4017 ICs.

Circuit Schematic

Figure 1. Circuit Schematic Wiper Speed Controller using NE555 and CD4017 ICs (Source: ElectronicsZone)

Component Parts

• NE555 IC
• CD4017 IC
• Tansistors
• Resistors
• Diode
• Capacitors
• All component parts please see in Figure 1 above

Description

Electronic circuit schematic like in Figure 1. above is Circuit Schematic Wiper Speed Controller using NE555 and CD4017 ICs. According ElectronicsZone site describe that a continuously working wiper in a car may prove to be a nuisance, especially when it is not raining heavily. By using the circuit described here one can vary sweeping rate of the wiper from once a second to once in ten seconds. The circuit comprises two timer NE555 ICs, one CD4017 decade counter, one TIP32 driver transistor, a 2N3055 power transistor (or TIP3055) and a few other discrete components. Timer IC1 is configured as a mono- stable multivibrator which produces a pulse when one presses switch S1 momentarily. This pulse acts as a clock pulse for the decade counter (IC2) which advances by one count on each successive clock pulse or the push of switch S1. Ten presets (VR1 through VR10), set for different values by trial and error, are used at the ten outputs of IC2. But since only one output of IC2 is high at a time, only one preset (at selected output) effectively comes in series with timing resistors R4 and R5 connected in the circuit of timer IC3 which functions in astable mode. As presets VR1 through VR10 are set for different values, different time periods (or frequencies) for astable multivibrator IC3 can be selected. The output of IC3 is applied to pnp driver transistor T1 (TIP32) for driving the final power transistor T2 (2N3055) which in turn drives the wiper motor at the selected sweep speed. The power supply for the wiper motor as well as the circuit is tapped from the vehicle?s battery itself. The duration of monostable multivibrator IC1 is set for a nearly one second period.

Please read more the Circuit Schematic Wiper Speed Controller using NE555 and CD4017 ICs from original source using link here.